Available shims
WARNING: This page is about a different variant/trim than selected.
AVAILABLE SHIMS (OUTPUT SHAFT)
| Size (mm) | Part no. |
|---|---|
| 0.65 0.70 0.75 0.80 |
020 311 391 P 020 311 391 Q 020 311 391 020 311 391 A |
| 0.85 0.90 0.95 1.00 |
020 311 391 B 020 311 391 C 020 311 391 D 020 311 391 E |
| 1.05 1.10 1.15 1.20 |
020 311 391 F 020 311 391 G 020 311 391 H 020 311 391 J |
| 1.25 1.30 1.35 1.40 |
020 311 391 K 020 311 391 L 020 311 391 M 020 311 391 N |
CAUTION:
Part numbers are listed for reference only. Always check with your Parts department for the latest information.
- Install selected shim -S3- (1.15 mm in example above) and drive tapered roller bearing outer race into clutch housing (see DETERMINING THICKNESS OF SHIM S3 ).
- Lubricate tapered roller bearing with gear oil and install output shaft.
- Tighten bolts for bearing cover to tightening torque.