Checking synchronizer ring
WARNING: This page is about a different variant/trim than selected.
- Press synchronizer ring onto gear cone and measure gap -a- with feeler gauge.
SYNCHRONIZER RING GAP -a- DIMENSIONS
| Gap -a- | Dimension (new) | Wear limit |
|---|---|---|
| 3rd gear | 1.15-1.75 mm (0.045-0.069 in.) | 0.5 mm (0.020 in.) |
| 4th gear | 1.3-1.9 mm (0.051-0.075 in.) | 0.5 mm (0.020 in.) |
| 5th gear |
CAUTION:
- When replacing synchronizer rings, always refer to parts catalog for the correct parts application.
- Synchronizer rings must not be interchanged.