LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 1999 >> Golf Wolfsburg Edition, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (5 SPD. Manual Transmission 020 (A3 Platform)) >> Manual Transmission - Controls Housing >> Transmission, removing and installing >> Installing >> Additional tightening torques for Cabrio only

Additional tightening torques for Cabrio only

WARNING: This page is about a different variant/trim than selected.

Transmission support on body

  1. - Bolt: 50 N.m (37 ft lb)
  2. - Nuts: 50 N.m (37 ft lb)
    3. Fig 1: Locating Transmission Support On Body Fasteners (Cabrio Only)
    G03361921Courtesy of VOLKSWAGEN OF AMERICA, INC.

Engine support on body

  1. - Nuts: 50 N.m (37 ft lb)
  2. - Bolt: 50 N.m (37 ft lb)
  3. - Spacers: under support
NOTE:
  • Install spacers -C- before installing the support.
  • A spacer plate that includes the spacers in a single unit is available as a replacement part.
    Fig 2: Locating Transmission Support On Body Fasteners (Cabrio Only)
    G03361922Courtesy of VOLKSWAGEN OF AMERICA, INC.
TORQUE SPECIFICATIONS (CABRIO ONLY)

Component Torque Specifications
Drive axle to drive flange 45 N.m (33 ft lb)
Slave cylinder bracket to transmission housing cover 30 N.m (22 ft lb)
scientia non olet · About LEMON Manuals