Shift linkage, adjusting: Notes

WARNING: This page is about a different variant/trim than selected.

Loosen clamp (arrow).

Fig 1: Loosening Selector Rod Clamp
Courtesy of VOLKSWAGEN OF AMERICA, INC.

Joint between selector rod and selector lever must move easily
Remove shift knob, boot, and frame: see SHIFT BOOT, INSTALLING .
Insert gauge 3104.
Gauge must not jam

Fig 2: Inserting 3104 Gauge To Align Selector Rod/Selector Lever
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Align selector rod/selector lever (with transmission in neutral) and tighten clamp.

CAUTION: DO NOT put components under stress.