Pedal cluster, servicing: Notes
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Do not re-use fasteners that are worn or deformed in normal use.
- Some fasteners are designed to be used only once, and are unreliable and may fail if used a second time. This includes, but is not limited to, nuts, bolts, washers, circlips and cotter pins. Always follow recommendations in this manual-replace these fasteners with new parts where indicated, and any other time it is deemed necessary by inspection.
CAUTION:
Before working on the pedal cluster:
- Obtain the security code for the anti-theft radio.
- Disconnect the battery Ground (GND) strap.
NOTE:
- Lubricate all bearings and friction surfaces with MoS2 grease.
- Before working on the pedal cluster, remove the left storage shelf: see DRIVER'S SIDE STORAGE COMPARTMENT, REMOVING AND INSTALLATING for Golf, GTI or Jetta. For Cabrio see, DRIVER'S SIDE STORAGE COMPARTMENT, REMOVING AND INSTALLATING .
The following list pertains to Fig 1.
- Mounting bracket
- With accelerator pedal
- With guide tube for clutch cable (arrow)
- Before removing, remove steering column together with steering tube
See STEERING COLUMN, STEERING COLUMN TUBE AND STEERING WHEEL, SERVICING .
- Nut
- Self-locking
- Always replace
- 25 N.m (18 ft lb)
- Stop buffer
- Bolt
- Qty: 2
- 25 N.m (18 ft lb)
- Pivot pin for clutch and brake pedals
- Installation position, see Installation position of clutch and brake pedal pivot pin
- Securing clip
- Removing, see CLUTCH PEDAL, REMOVING AND INSTALLING
- Installing, see INSTALLING
- Bolt
- 25 N.m (18 ft lb)
- Nut
- Self-locking
- Always replace
- 25 N.m (18 ft lb)
- Support
- Brake pedal
- Clutch pedal
- Removing and installing, see CLUTCH PEDAL, REMOVING AND INSTALLING
- Retainer
- Not applicable for USA/Canada
- Securing clip
- Removing, see CLUTCH PEDAL, REMOVING AND INSTALLING
- Over-center spring
- Removing and installing, see OVER-CENTER SPRING, REMOVING AND INSTALLING
- Over-center spring support
- Install in mounting bracket
- Nut
- Not applicable for USA/Canada
- Mounting bracket
- Not applicable for USA/Canada
- Master cylinder
- Not applicable for USA/Canada
- Nut
- Not applicable for USA/Canada