Clutch control, servicing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Before replacing the clutch cable, check operation, see CLUTCH CABLE ADJUSTING MECHANISM, CHECKING FUNCTION AND REPAIRING .
The following list pertains to Fig 1.
- Clutch cable
- Removing and installing, see CLUTCH CABLE, REMOVING AND INSTALLING
- - Clutch cable
- With integral vibration damper (arrow)
- Removing and installing, see CLUTCH CABLE, REMOVING AND INSTALLING
- Rubber stop
- Washer
- Support plate
- For clutch cable, in clutch pedal
- Dust boot
- Mounting bracket
- Removing and installing, see OVER-CENTER SPRING, REMOVING AND INSTALLING
- Clutch pedal
- Removing and installing, see CLUTCH PEDAL, REMOVING AND INSTALLING
- Stop buffer
- Release lever
- Washer
- Nut
- 25 N.m (18 ft lb)
- Balance weight
- Replaces balance weight -15- from August 1993, for vehicles with diesel or turbo diesel engine
NOTE: The balance weight can be installed in all previous vehicles together with a clutch cable (item -2-) in case of a complaint. - Clutch cable attachment components
- Not used when balance weight -15- is installed
- Balance weight
- With integral clutch cable attachment components
- Installed in combination with clutch cable -2-
- Replaced by balance weight -13- from August 1993, for vehicles with diesel or turbo diesel engine
- Rubber buffer
- Transmission
- Rubber guide
- Bracket
- Bolt
- Bracket to body