Clutch cable, removing and installing: Removing

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not kink the clutch cable, otherwise the adjusting mechanism may not function properly.

Depress clutch pedal down to stop at least 5 times.
Attach retaining strap so that eyelet (arrow -1-) is above protective boot.

Fig 1: Attaching Clutch Cable Retaining Strap
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Compress adjusting mechanism in area of protective boot.

NOTE: If the adjusting mechanism cannot be compressed, it is faulty. Checking function of clutch cable, see CLUTCH CABLE ADJUSTING MECHANISM, CHECKING FUNCTION AND REPAIRING .

Hook tabs of retaining strap onto pins (arrow -2-) of adjusting mechanism (second technician required).
Disconnect clutch cable attachment components from release shaft lever.
Remove over-center spring, see OVER-CENTER SPRING, REMOVING AND INSTALLING .
Disconnect clutch cable from clutch pedal and remove cable.

Fig 2: Disconnecting Clutch Cable Attachment Components From Release Shaft Lever
Courtesy of VOLKSWAGEN OF AMERICA, INC.