Clutch cable tensioned

WARNING: This page is about a different variant/trim than selected.

Route clutch cable end piece through bracket on transmission and through release shaft lever.

CAUTION: Be careful to not damage the plastic sleeve on the clutch cable.

Connect attachment parts to release shaft lever and clutch cable (shown here on vehicle without balance weight).

Fig 1: Shaft Lever And Clutch Cable Attachment Parts
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Hook clutch cable into wire retainers.
Remove retaining strap in such a way that it can be used again.
Install over-center spring, see INSTALLING .
Depress clutch pedal down to stop at least 5 times.
Check operation of clutch cable adjusting mechanism, see CLUTCH CABLE ADJUSTING MECHANISM, CHECKING FUNCTION AND REPAIRING .