Diagnostic Mode 07: Check test results of components that are continuously monitored

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Mode 07 displays all stored DTCs of emission related components and systems which are continuously monitored.

NOTE:

Depending on scan tool and protocol used, diagnostic mode 07 and the information provided may be referred to by a different name.

Test requirements

No DTCs stored in the DTC memory.
Coolant temperature at least 80 ° C.

Procedure

Connect the scan tool.
Start the engine and run at idle.

NOTE:

If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

Select "Mode 7: Check test results of components that are continuously monitored".

The number of stored DTCs or "0 malfunctions detected" will be displayed scan tool screen.

Switch the ignition off.
Refer to the following DTC tables for the diagnostic repair procedure:

SAE P0xxxDTCs → SAE P0xxx DTCs .
SAE P1xxxDTCs → SAE P1xxx-DTCs .
SAE P2xxx DTCs → SAE P2xxx DTCs .

Switch the ignition off.
End of diagnosis.