SAE P2xxx DTCs

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

09A Transmission

DTC	Error Message	Diagnostic Procedure	Malfunction Criteria and Threshold Value	Secondary Parameters with Enable Conditions	Monitoring Time Length	Frequency of checks, MIL Illumination
P2122	Throttle/Pedal Position Sensor/Switch "D" Circuit Low Input	Check the Throttle Position (TP) Sensor G79 / Accelerator Pedal Position Sensor 2 G185. Refer to → Throttle Position (TP) Sensor G79 / Accelerator Pedal Position Sensor 2 G185 , checking .	Signal invalid, Error value received	CAN-bus must be active	30 ms
P2181	Cooling System Performance	Check Engine Coolant Temperature (ECT) Sensor -G62-. Refer to Engine Coolant Temperature (ECT) Sensor G62 , checking
P2637	Torque Management Feedback Signal A	Check CAN BUS connection between Motronic Engine Control Module (ECM) J220 and Transmission Control Module (TCM) J217. Refer to → CAN-Bus terminal resistance, Transmission Control Module (TCM) J217 to Engine Control Module (ECM) J220 checking .	ECM not able to follow the torque request, Bit torque management is set	CAN-bus must be active	30 ms