Part II
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
1 - Knock sensor 1 G61
- Checking
2 - 20 Nm
- Tightening torque affects function of Knock Sensor (KS)
3 - Knock sensor 2 G66
- Checking
4 - Oil dipstick
- Oil level must not be above max. mark!
- Marks Markings on oil dipstick under Lubrication system components, assembly overview
5 - Inlet spout
- For oil dipstick
6 - O-ring
- Replace
7 - Coolant line
8 - 20 Nm
9 - Oil filter bracket
- Disassembling and assembling
10 - 15 Nm plus an additional 1 / 4 turn (90 ° )
- Replace
11 - Oil cooler
- Coat contact area to oil filter bracket, outside the seal, with AMV 188 100 02. (Part numbers are for reference only. Always check with your Parts Department for the latest part number information).
- Ensure sufficient clearance to surrounding components
- See note, refer to Engine, disassembling and assembling
12 - 25 Nm
13 - Oil filter element
- Remove with tension strap
- Fasten by hand
- Observe installation instructions for oil filter
14 - Gasket
- Replace
15 - 10 Nm
16 - Engine speed (RPM) sensor G28
- Checking
17 - Connecting piece
18 - 15 Nm
19 - O-ring
- Replace
20 - Coolant thermostat
- Removing and installing, refer to Coolant thermostat, removing and installing
- Note installation position, refer to Coolant thermostat, removing and installing
- Checking: Heat up thermostat in water
- Opening begins approx. 86 ° C
- Opening lift min. 7 mm
21 - 45 Nm
22 - Compact bracket
- For generator, air conditioning compressor, and power steering pump
23 - Right engine bracket