A-Pillar Upper Trim Panel Removal And Installation/Replacement

Mobile Repair Possible: Van/Car

WARNING: Explosive materials
Failure to follow specified procedures may result in death or serious injury due to improper handling of Airbags possible.

Only appropriately trained persons may carry out work on pyrotechnic components or the Airbag Control Unit.
Perform SRS disabling procedure prior to commencing work.
When replacing components of the SRS system, never install used or non-genuine components.
Pyrotechnic Components must be handled and scrapped appropriately.

Removal Procedure:

The procedure for the left-hand component is identical to that for the right-hand side.

There is potential for inadvertent deployment of SRS systems during repairs if the system has not been properly disabled. Refer to AIRBAG SUPPLEMENTARY RESTRAINT SYSTEM (SRS) DISABLING AND ENABLING
NOTE: Ensure the 2-minute wait time has been observed before proceeding to next step.
Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION

Courtesy of VINFAST, LLC
Unclip and remove cover (1).

Courtesy of VINFAST, LLC

Removal Note: Do not use sharp-edged tools anywhere near the head airbag.
Loosen 2 clips (2) under A-pillar upper trim panel (1) with suitable tools in arrow direction.
Turn the lock (1) 90° with a suitable tool and unlock it.

Courtesy of VINFAST, LLC
Dismount and remove the A-pillar trim (1) from the dashboard (2).
Installation Procedure:

Courtesy of VINFAST, LLC

Installation note: Check clips (1) for damage and replace if needed.

Installation is the reverse of removal procedure, noting the following.
Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION