Removal [06/2020 - 12/2021]: Procedure

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Refer to PRECAUTION [06/2020 - 10/2022]

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Refer to BEFORE DISCONNECTING BATTERY [06/2020 - 10/2022]

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Refer to REMOVAL [06/2020 - 12/2021]

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [06/2020 - 12/2021]
REMOVE NO. 1 CONSOLE BOX DUCT
Refer to PROCEDURE - Step 36

REMOVE AIRBAG ECU ASSEMBLY

Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
WARNING:
- Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.

Pull out each connector with its connector lock pushed to disconnect the 3 connectors.

	Push the Connector Lock
	Pull Out the Lock Lever

NOTE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

Remove the 3 bolts and airbag ECU assembly.

NOTE:

If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.