Removal [06/2020 - ]: Procedure

REMOVE BACK DOOR CENTER GARNISH
Refer to PROCEDURE - Step 1
REMOVE BACK DOOR SIDE GARNISH LH
Refer to PROCEDURE - Step 2
REMOVE BACK DOOR SIDE GARNISH RH
HINT:

Use the same procedure as for the LH side.
REMOVE BACK DOOR HANDLE COVER
Refer to PROCEDURE - Step 4
REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Refer to PROCEDURE - Step 5

REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Remove the 4 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Put protective tape around the back door outside garnish sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Insert moulding remover A in the position shown in the illustration, set it so that it is level with the back door outside garnish sub-assembly and detach the claw.

Insert molding remover A in Here

Move the molding remover A in this direction

Use the same procedure for the other side.
Detach the clip in the order shown in the illustration and remove the back door out side garnish sub-assembly.

Fig 1: Back Door Out Side Garnish Sub-Assembly Loosening Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002