Removal [12/2022 - ]: Procedure

SECURE VEHICLE

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fully apply the parking brake and chock a wheel.
WARNING:
- Make sure to apply the parking brake and chock a wheel before performing this procedure.
- If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

REMOVE FRONT DOOR SCUFF PLATE LH (w/ Knee Airbag)
Refer to PROCEDURE - Step 10 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 10 [03/2023 - ]
REMOVE COWL SIDE TRIM BOARD LH (w/ Knee Airbag)
Refer to PROCEDURE - Step 11 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 11 [03/2023 - ]
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
Refer to PROCEDURE - Step 4 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 4 [03/2023 - ]
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 5 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 5 [03/2023 - ]
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
See step 1
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7 [12/2022 - 03/2023] , or refer to PROCEDURE - Step 7 [03/2023 - ]

REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

NOTE:

When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.