On-Vehicle Inspection [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 7 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 7 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 7 [09/2022 - 11/2022]
REMOVE REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 8 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 8 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 8 [09/2022 - 11/2022]

INSPECT MANUAL TRANSAXLE OIL

Remove the manual transmission filler plug and gasket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the manual transmission filler plug opening.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	0 to 5 mm (0 to 0.197 in.)

NOTE:

An excessively large or small amount of manual transaxle oil may cause problems.

Check for oil leakage when the oil level is low.

Install a new gasket and the manual transmission filler plug.

Torque: 39.2 N.m (400 kgf/cm, 29 ft.lbf)

INSTALL REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 72 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 72 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 72 [09/2022 - 11/2022]
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 74 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 74 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 74 [09/2022 - 11/2022]