DTC P0107: Manifold Absolute Pressure / Barometric Pressure Circuit Low Input; DTC P0108: Manifold Absolute Pressure / Barometric Pressure Circuit High Input [01/2019 - 03/2019]: Description

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

The manifold absolute pressure sensor detects pressure inside the intake manifold as an absolute pressure with a built-in sensor and outputs it as voltage. Based on the voltage from the manifold absolute pressure sensor, the ECM controls the purge VSV and corrects any errors in the air fuel ratio due to change in pressure.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory
P0107	Manifold Absolute Pressure / Barometric Pressure Circuit Low Input	The output voltage from the manifold absolute pressure sensor is less than 0.5 V for 0.5 seconds (1 trip detection logic).	Open or short in manifold absolute pressure sensor circuit Manifold absolute pressure sensor ECM	Comes on	DTC stored
P0108	Manifold Absolute Pressure / Barometric Pressure Circuit High Input	The output voltage from the manifold absolute pressure sensor is higher than 4.5 V for 0.5 seconds (1 trip detection logic).	Open or short in manifold absolute pressure sensor circuit Manifold absolute pressure sensor ECM	Comes on	DTC stored

HINT:

When any of these DTCs are output, check the manifold absolute pressure using the Techstream. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

MAP	Malfunction
Approximately 0 kPa (0 psi)	Short to ground in PIM circuit to ground Short in PIM circuit to EPIM circuit Open in VCPM circuit
130 kPa (18.85 psi) or higher	Short in VCPM circuit to PIM circuit Open in PIM circuit Open in EPIM circuit