DTC P0106: Manifold Absolute Pressure Circuit Problem [03/2019 - 11/2022]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0106)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Powertrain > Engine and ECT > Trouble Codes
Result
Result Proceed to DTC P0106 is output A DTC P0106 and other DTCs are output B HINT:
If any DTCs other than P0106 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2019 - 04/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [04/2020 - 09/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2022 - 11/2022]
Result:
A
See step 2
- READ VALUE USING TECHSTREAM (MAP)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.
Powertrain > Engine and ECT > Data List
Tester Display MAP - According to the display on the Techstream, read the Data List.
- Start the engine.
- According to the display on the Techstream, read the Data List.
Standard
Engine Condition Techstream Display Ignition Switch ON 80 to 110 kPa (11.6 to 15.95 psi) Idling 20 to 40 kPa (2.9 to 5.8 psi) Result
Proceed to OK NG
Result:
OK
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [01/2019 - 11/2022]
Result:
NG
See step 3
- CHECK INTAKE SYSTEM
- Check the intake system for vacuum leaks.
Refer to ON-VEHICLE INSPECTION [01/2019 - 11/2022]
OK
No leaks from intake system.
HINT:
Perform "Inspection After Repair" after repairing or replacing the intake system.
Refer to INITIALIZATION [01/2019 - 11/2022]
Result
Proceed to OK NG
Result:
OK
REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR. Refer to REMOVAL [01/2019 - 11/2022]
Result:
NG
REPAIR OR REPLACE INTAKE SYSTEM
- Check the intake system for vacuum leaks.