LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Automatic Transaxle System (K313) - Service Information) >> Transmission Control Cable >> Removal [03/2019 - 09/2022] >> Procedure

Removal [03/2019 - 09/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
        GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
  2. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 1

  4. REMOVE RADIATOR SUPPORT OPENING COVER 

    Refer to PROCEDURE - Step 1

  5. REMOVE INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 4

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 2

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  9. REMOVE ECM 

    Refer to PROCEDURE - Step 8

  10. REMOVE BATTERY 

    Refer to REMOVAL [03/2019 - 09/2022]

  11. DISCONNECT ENGINE WIRE 

    See step  11

  12. REMOVE BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

  13. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    Refer to REMOVAL [01/2019 - 11/2022]

  14. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR 
    1. Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.
      GTY905652Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [01/2019 - 09/2022]

  16. REMOVE FLOOR SHIFT TRANSMISSION CONTROL SELECT CABLE 
    1. Move the shift lever to N.
    2. Disconnect the floor shift transmission control select cable from the transmission floor shift assembly.
      GTY842350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a screwdriver, pull out the stopper of the floor shift transmission control select cable.
      GTY891233Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Stopper
      NOTE:

      Do not remove the stopper. If it is removed, reinstall it to its original position.

    4. Turn the nut of the floor shift transmission control select cable approximately 180° counterclockwise and, while holding the nut in that position, disconnect the floor shift transmission control select cable from the transmission floor shift assembly.
      GTY897253Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Stopper
      *b Nut
      *c Turn approximately 180°
      NOTE:
      • Do not turn the nut excessively as the internal spring may come off and the floor shift transmission control select cable will not be reusable.
      • Do not forcibly pull the floor shift transmission control select cable into the cabin.
    5. Remove the nut to disconnect the floor shift transmission control select cable from the control shaft lever.
      GTY490786Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the clip to separate the floor shift transmission control select cable from the No. 1 transmission control cable bracket.
    7. GTY747456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the nut.

    8. Disengage the guide to disconnect the floor shift transmission control select cable from the vehicle body.
    9. Remove the 2 nuts and floor shift transmission control select cable from the vehicle body.
      GTY747480Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals