Replacement [01/2019 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 7 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 7 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 7 [09/2022 - 11/2022]
REMOVE REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 8 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 8 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 8 [09/2022 - 11/2022]
REPLACE CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Refer to PROCEDURE - Step 3
ADD SPECIFIED AMOUNT OF FLUID
See step 5
ADJUST FLUID TEMPERATURE (when Using the Techstream)
See step 6
ADJUST FLUID TEMPERATURE (when Not Using the Techstream)
See step 7
ADJUST FLUID LEVEL
See step 8
PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET
NOTE:
If approximately 50% or more of the CVT fluid has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.

Refer to INITIALIZATION [01/2019 - 11/2022]
REBUILD WORK
See step 10
INSTALL REAR ENGINE UNDER COVER LH
Refer to PROCEDURE - Step 72 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 72 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 72 [09/2022 - 11/2022]
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 74 [01/2019 - 03/2019] , or refer to PROCEDURE - Step 74 [03/2019 - 09/2022] , or refer to PROCEDURE - Step 74 [09/2022 - 11/2022]