LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Transfer Case System (GF1A) - Service Information) >> Transfer Assembly >> Removal [08/2020 - 12/2021] >> Procedure

Removal [08/2020 - 12/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [08/2020 - 12/2021]

  2. REMOVE PROPELLER SHAFT HEAT INSULATOR 

    Refer to PROCEDURE - Step 18

  3. REMOVE NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY 
    1. Remove the 2 bolts and No. 1 propeller shaft heat insulator bracket sub-assembly.
      GTY934333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE MOUNTING INSULATOR 

    Refer to PROCEDURE - Step 19

  5. REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  6. REMOVE TRANSFER ASSEMBLY 
    1. for Type A:

      Remove the 6 nuts, 2 bolts and transfer from the transaxle.

      GTY888515Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY869846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      for Type B:

      Remove the 8 nuts and transfer assembly from the transaxle.

  7. REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT 

    Refer to PROCEDURE - Step 30

scientia non olet · About LEMON Manuals