Installation [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL FUEL PUMP CONTROL ECU BRACKET
1. Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts.
  Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf)
INSTALL FUEL PUMP CONTROL ECU
1. Install the fuel pump control ECU to the vehicle body with the nut.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
2. Connect the 2 fuel pump control ECU connectors.
INSTALL ROOM PARTITION BOARD LH
Refer to PROCEDURE - Step 4
INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
Refer to PROCEDURE - Step 6 [04/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - ]
INSTALL REAR SEAT SHOULDER BELT COVER
Refer to PROCEDURE - Step 7 [04/2018 - 08/2020] , or refer to PROCEDURE - Step 7 [08/2020 - ]
INSTALL ROOF SIDE INNER GARNISH LH
Refer to PROCEDURE - Step 20 [04/2018 - 08/2020] , or refer to PROCEDURE - Step 18 [08/2020 - ]
INSTALL ROOF SIDE INNER GARNISH RH
HINT:

Use the same procedure as for the LH side.
INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH
Refer to PROCEDURE - Step 21 [04/2018 - 08/2020] , or refer to PROCEDURE - Step 19 [08/2020 - ]
INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.
CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 1
CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Refer to PROCEDURE - Step 1
CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
Refer to PROCEDURE - Step 9 [04/2018 - 08/2020] , or refer to PROCEDURE - Step 9 [08/2020 - ]
CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.
INSTALL CENTER STOP LIGHT SET
Refer to INSTALLATION [04/2018 - ]
INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System)
Refer to PROCEDURE - Step 15
INSTALL REAR SEAT ASSEMBLY
Refer to INSTALLATION [04/2018 - 08/2020] , or refer to INSTALLATION [08/2020 - ]