Removal [08/2021 -]: Procedure

Refer to REMOVAL [08/2021 -] 

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 2

1. Disengage the clamp to separate the wire harness from the brake pedal support assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove the 2 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Depending on the vehicle, the clips may not be installed.

4. Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster support base.
   NOTE:

   Be careful not to deform the bracket of the instrument panel reinforcement assembly.

1. Remove the brake pedal return spring from the brake pedal support assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disengage the 2 claws and remove the stop light switch mounting adjuster.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the brake pedal pad from the brake pedal support assembly.