Removal [07/2020 - ]: Procedure

CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
Refer to PROCEDURE - Step 2 [07/2020 - 12/2021] , or refer to PROCEDURE - Step 2 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]
REMOVE LOWER STEERING COLUMN COVER
Refer to PROCEDURE - Step 2
REMOVE UPPER STEERING COLUMN COVER
Refer to PROCEDURE - Step 3

REMOVE TURN SIGNAL SWITCH

Remove the 2 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the turn signal switch as shown in the illustration.

*a	Protective Tape
	Remove in this Direction

NOTE:

If the claw is pulled with excessive force, it may break.