LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza LE >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Video System - Service Information >> Radio Receiver >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

  1. PRECAUTION 

    Refer to PRECAUTION [10/2022 - ]

  2. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL (for 8 Inch Display) 

    Refer to PROCEDURE - Step 27

  3. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for 8 Inch Display) 
    1. Remove the 4 bolts.
      GTY1120661Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 6 clips to remove the radio and display receiver assembly with bracket as shown in the illustration.
      GTY1120689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hand Here
      Remove in this Direction
    3. Disconnect each connector.
  4. REMOVE NO. 1 RADIO RECEIVER BRACKET (for 8 Inch Display) 
    1. Remove the 2 screws and No. 1 radio receiver bracket.
      GTY987677Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE NO. 2 RADIO RECEIVER BRACKET (for 8 Inch Display) 
    1. Remove the 2 screws and No. 2 radio receiver bracket.
      GTY987678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for 8 Inch Display) 

    Refer to PROCEDURE - Step 4

  7. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for 8 Inch Display) 
  8. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL (for 12.3 Inch Display) 

    Refer to PROCEDURE - Step 27

  9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for 12.3 Inch Display) 
    1. Remove the 4 bolts.
      GTY1122066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 6 clips to remove the radio and display receiver assembly with bracket as shown in the illustration.
      GTY1120062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Disconnect each connector.
  10. REMOVE NO. 1 RADIO BRACKET (for 12.3 Inch Display) 
    1. Remove the 2 screws and No. 1 radio bracket.
      GTY1122067Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE NO. 2 RADIO BRACKET (for 12.3 Inch Display) 
    1. Remove the 2 screws and No. 2 radio bracket.
      GTY1120668Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE RADIO RECEIVER ASSEMBLY (for 12.3 Inch Display) 
scientia non olet · About LEMON Manuals