LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> RAV4 Prime SE >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Cruise Control System - Service Information (PHEV) >> Millimeter Wave Radar Sensor >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

  1. REMOVE HOOD LOCK ASSEMBLY 

    Refer to PROCEDURE - Step 8 [06/2020 - 10/2023] , or refer to PROCEDURE - Step 8 [10/2023 - 11/2024] , or refer to PROCEDURE - Step 8 [11/2024 - ]

  2. REMOVE UPPER RADIATOR AIR GUIDE PLATE 

    Refer to PROCEDURE - Step 2

  3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY 
    NOTE:

    Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.

    1. Disconnect the connector.
      GTY1008080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and screw.
      GTY1007808Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Screw
    3. Detach the guide and remove the millimeter wave radar sensor assembly.
scientia non olet · About LEMON Manuals