Installation [12/2022 - ]: Procedure

Torque: 80 N.m (816 kgf/cm, 59 ft.lbf) 

Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Temporarily install the lower side of the disc brake cylinder assembly LH with the bolt.
      NOTE:

      Do not apply excessive force to the flexible hose.

   2. Remove the SST.
   3. Connect the disc brake cylinder assembly LH to the steering knuckle LH with the 2 bolts.

      Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

   4. Connect the flexible hose to the front flexible hose bracket LH with the 2 bolts.

      Torque: 20 N.m (204 kgf/cm, 15 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the sensor clamp with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      NOTE:

      Do not install the clamp while the front skid control sensor wire LH is twisted.

   2. Connect the skid control sensor wire connector.
   3. Install the sensor clamp with the nut.

      Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

      NOTE:

      Do not install the clamp while the front skid control sensor wire LH is twisted.

Refer to INSTALLATION [11/2020 - ]

Refer to TEST MODE PROCEDURE [11/2020 - ]

HINT: 

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - 12/2023] , or refer to AUTOMATIC LEARNING CHART [12/2023 - ]

Refer to WORK PROCEDURE [12/2022 - 12/2023] , or refer to WORK PROCEDURE [12/2023 - ]