Installation [12/2022 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   -

   -

   1. When reusing the front disc LH:
      1. Align the matchmarks of the front disc LH and front axle hub sub-assembly, and install the front disc LH.
   2. When replacing the front disc LH:
      1. Inspect the front disc runout.

         See step  5

      2. Select the installation position where the front disc has minimal runout, and install the front disc LH.
   3. Temporarily install the 5 hub nuts.

Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque: 39.2 N.m (400 kgf/cm, 29 ft.lbf) 

      NOTE:

      Install the front flexible hose lock securely into the lock hole in the disc brake cylinder assembly.

Refer to PROCEDURE - Step 3

Refer to BLEEDING [11/2020 - ]

Refer to INSTALLATION [11/2020 - ]

HINT: 

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - 12/2023] , or refer to AUTOMATIC LEARNING CHART [12/2023 - ]