LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Land Cruiser Base >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pressure Sensor >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. GTY237344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      NOTE:

      Do not allow adhesive to contact the oil hole.

      GTY541116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY571679Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Install the oil pressure sender gauge.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine within 1 hour after installation.

    3. GTY593084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Connect the sender gauge connector.

  2. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 2

  3. INSPECT FOR OIL LEAK 

    See step  7

  4. INSTALL NO. 1 ENGINE UNDER COVER SUBASSEMBLY 

    Refer to PROCEDURE - Step 49

  5. INSTALL FRONT FENDER SPLASH SHIELD SUBASSEMBLY LH 

    Refer to PROCEDURE - Step 14

  6. INSTALL FRONT FENDER SPLASH SHIELD SUBASSEMBLY RH 

    Refer to PROCEDURE - Step 15

scientia non olet · About LEMON Manuals