LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Highlander Platinum, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Fuel System (T24A-FTS) - Service Information) >> FUEL PUMP (for High Pressure) >> Removal [11/2023 - ] >> Procedure

Removal [11/2023 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [11/2023 - ]

  2. DISCHARGE FUEL SYSTEM PRESSURE 

    Refer to PRECAUTION [10/2022 - ]

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23

  5. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 20

  7. DISCONNECT ENGINE WIRE 

    Refer to PROCEDURE - Step 6

  8. REMOVE PURGE VALVE (PURGE VSV) 

    Refer to PROCEDURE - Step 17

  9. REMOVE AIR TUBE ASSEMBLY 

    Refer to PROCEDURE - Step 8

  10. DISCONNECT FUEL TUBE SUB-ASSEMBLY 
    1. GTY1104183Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the fuel tube sub-assembly from the fuel pump assembly.

        Refer to PRECAUTION [10/2022 - ]

  11. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY 
    WARNING:

    To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.

    1. GTY1108811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
      2. Loosen the 2 bolts of the fuel pump assembly.
      3. Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly and fuel pump assembly.
  12. REMOVE FUEL PUMP ASSEMBLY 
    NOTE:

    When replacing the fuel pump assembly, it is necessary to replace the No. 1 fuel pipe sub-assembly with a new one.

    1. GTY1076681Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE FUEL PUMP SPACER GASKET 
    1. GTY1076680Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE FUEL PUMP LIFTER ASSEMBLY 
    1. GTY1076667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals