LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column - Service Information (Except Hybrid) >> Steering Wheel >> Installation [03/2020 - ] >> Procedure

Installation [03/2020 - ]: Procedure

  1. INSTALL NO. 1 SWITCH WIRE (w/ Shift Paddle Switch) 

    For UB80E: Refer to PROCEDURE - Step 1

    For UB80F: Refer to PROCEDURE - Step 1

    For UA80E: Refer to PROCEDURE - Step 1

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch) 

    For UB80E: Refer to PROCEDURE - Step 2

    For UB80F: Refer to PROCEDURE - Step 2

    For UA80E: Refer to PROCEDURE - Step 2

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    See step  1

  4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7 [03/2020 - 10/2020] , or refer to PROCEDURE - Step 7 [10/2020 - ]

  6. INSTALL STEERING WHEEL ASSEMBLY 
    1. Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
      GTY741960Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    2. Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.

      Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf) 

    3. Connect each connector.
  7. CHECK STEERING WHEEL CENTER POINT 
  8. INSTALL HORN BUTTON ASSEMBLY 

    Refer to INSTALLATION [06/2017 - ]

scientia non olet · About LEMON Manuals