LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission System (UB80E) - Service Information (2 Of 3) (Except Hybrid) >> Shift Paddle Switch >> Installation [03/2017 - ] >> Procedure

Installation [03/2017 - ]: Procedure

  1. INSTALL NO. 1 SWITCH WIRE 

    HINT: 

    Perform this procedure only when replacement of the No. 1 switch wire is necessary.

    1. Engage the 2 guides to install the No. 1 switch wire to the steering wheel assembly.
  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.
    2. Engage the 2 clamps.
    3. Engage the 4 claws to install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly.
    4. Install 2 new screws.

      Torque: 1.7 N.m (17 kgf/cm, 15 in.lbf) 

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [03/2017 - 06/2017] , or refer to INSTALLATION [06/2017 - 03/2020] , or refer to INSTALLATION [03/2020 - ]

scientia non olet · About LEMON Manuals