LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System - Service Information (2 Of 2) (Except Hybrid) >> COMPRESSOR (for A25A-FKS) >> Removal [06/2017 - 10/2020] >> Procedure

Removal [06/2017 - 10/2020]: Procedure

  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM 

    For HFC-134a (R134a):

    Refer to PROCEDURE - Step 1

    For HFO-1234yf (R1234yf):

    Refer to PROCEDURE - Step 1

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [03/2017 - ]

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  4. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 20 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 20 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 20 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 21 [03/2020 - 10/2020]

  5. DISCONNECT NO. 5 WATER BY-PASS HOSE 

    Refer to PROCEDURE - Step 17

  6. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor assembly with pulley.
      GTY774318Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  7. DISCONNECT SUCTION HOSE SUB-ASSEMBLY 
    1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
      GTY766848Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the O-ring from the suction hose sub-assembly.
      NOTE:

      Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  8. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY 
    1. Disconnect the connector.
      GTY768085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector.
      GTY766847Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. For Type A:
      1. Remove the 2 bolts and 2 nuts.
        GTY764543Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Bolt
        Nut
      2. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.
        GTY766845Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. For Type B:
      1. Remove the 4 bolts and compressor assembly with pulley.
        GTY751973Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals