Installation [03/2017 - 09/2019]: Procedure

INSTALL OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY)

Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).

Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adhesive 1344
*b	Oil Inlet Port

NOTE:

Do not apply adhesive to the oil inlet port of the oil pressure sensor (oil pressure sender gauge assembly).
Install the oil pressure sensor (oil pressure sender gauge assembly) within 3 minutes of applying adhesive.

Using a 27 mm deep socket wrench, install the oil pressure sensor (oil pressure sender gauge assembly) to the cylinder block sub-assembly.
Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
Connect the oil pressure sensor (oil pressure sender gauge assembly) connector.

INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 6 [06/2017 - 09/2019]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 67 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 67 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 67 [08/2018 - 03/2020]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 68 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 68 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 68 [08/2018 - 03/2020]
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 69 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 69 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 69 [08/2018 - 03/2020]
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 70 [03/2017 - 06/2017] , or refer to PROCEDURE - Step 70 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 70 [08/2018 - 03/2020]