LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information (1 Of 2) (Except Hybrid) >> Rear Bumper >> Disassembly [06/2017 - 09/2019] >> Procedure

Disassembly [06/2017 - 09/2019]: Procedure

  1. REMOVE REAR CENTER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 2

    HINT: 

    Use the same procedure for the RH side and LH side.

  2. REMOVE REAR CORNER ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 3

    HINT: 

    Use the same procedure for the RH side and LH side.

  3. REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 5

    HINT: 

    Use the same procedure for the RH side and LH side.

  4. REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) 

    Refer to PROCEDURE - Step 6

    HINT: 

    Use the same procedure for the RH side and LH side.

  5. REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ Intuitive Parking Assist System) 
  6. REMOVE REFLEX REFLECTOR ASSEMBLY LH 
    GTY772737Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the screw.
    2. Disengage the claw and guide to remove the reflex reflector assembly LH.
      GTY759638Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE REFLEX REFLECTOR ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  8. REMOVE LOWER REAR BUMPER COVER (for Type A) 
    1. Remove the 2 screws.
      GTY753164Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 clips.
    3. Disengage the 12 claws to remove the lower rear bumper cover.
      GTY753177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE REAR BUMPER EXTENSION MOULDING LH (for Type B) 
    1. Disengage the 4 claws to remove the rear bumper extension moulding LH.
      GTY759637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE REAR BUMPER EXTENSION MOULDING RH (for Type B) 

    HINT: 

    Use the same procedure as for the LH side.

  11. REMOVE REAR BUMPER CORNER EXTENSION LH (for Type B) 
    1. Disengage the 4 claws and 4 guides to remove the rear bumper corner extension LH.
      GTY762056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE REAR BUMPER CORNER EXTENSION RH (for Type B) 

    HINT: 

    Use the same procedure as for the LH side.

  13. REMOVE REAR BUMPER PAD 
    1. Remove the rear bumper pad.
      GTY759572Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

  14. REMOVE SPARE WHEEL COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  15. REMOVE SPARE WHEEL COVER TRAY 

    Refer to PROCEDURE - Step 2

  16. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK 

    Refer to PROCEDURE - Step 3

  17. REMOVE LUGGAGE COMPARTMENT DOOR STRIKER COVER 

    Refer to PROCEDURE - Step 4

  18. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 5

  19. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH 

    Refer to PROCEDURE - Step 6

  20. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH 

    Refer to PROCEDURE - Step 7

  21. REMOVE REAR BUMPER SIDE RETAINER LH 
    1. Remove the screw.
      GTY772736Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 3 clips as shown in the illustration.
      GTY743039Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    3. Disengage the 2 claws as shown in the illustration.
      GTY749764Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
    4. Disengage the guide to remove the rear bumper side retainer LH.
  22. REMOVE REAR BUMPER SIDE RETAINER RH 

    HINT: 

    Use the same procedure as for the LH side.

  23. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH 

    Refer to PROCEDURE - Step 9

  24. REMOVE REAR COMBINATION LIGHT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  25. REMOVE REAR BUMPER UPPER RETAINER LH 
    1. Remove the screw and rear bumper upper retainer LH.
      GTY764050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  26. REMOVE REAR BUMPER UPPER RETAINER RH 

    HINT: 

    Use the same procedure as for the LH side.

  27. REMOVE REAR BUMPER SIDE SEAL LH 
    1. Remove the 2 grommets.
      GTY764066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for Single Type:
      GTY759574Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 3 clips and rear bumper side seal LH.
    3. for Dual Type:
      GTY772809Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 clips and rear bumper side seal LH.
  28. REMOVE REAR BUMPER SIDE SEAL RH 
    1. Remove the 2 grommets.
      GTY773718Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 clips and rear bumper side seal RH.
      GTY772722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  29. REMOVE REAR BUMPER ENERGY ABSORBER (for Type A) 
    1. Disengage the 2 guides to remove the rear bumper energy absorber as shown in the illustration.
      GTY759222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  30. REMOVE REAR BUMPER ENERGY ABSORBER (for Type B) 
    1. Disengage the 2 guides to remove the rear bumper energy absorber as shown in the illustration.
      GTY753432Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  31. REMOVE REAR BUMPER REINFORCEMENT 
    1. Remove the 6 bolts and rear bumper reinforcement.
      GTY772739Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals