Installation [10/2017 - 12/2021]: Procedure

INSTALL SPARK PLUG
HINT:

Perform "Inspection After Repair" after replacing a spark plug.
- w/ Canister Pump Module:
  Refer to INITIALIZATION [02/2017 - ]
- w/o Canister Pump Module:
  Refer to INITIALIZATION [02/2017 - ]
1. Install the 4 spark plugs to the cylinder head sub-assembly.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
  
  NOTE:
  If a spark plug has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL NO. 2 CYLINDER HEAD COVER
Refer to PROCEDURE - Step 4
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing a spark plug or ignition coil assembly.
  - w/ Canister Pump Module:
    Refer to INITIALIZATION [02/2017 - ]
  - w/o Canister Pump Module:
    Refer to INITIALIZATION [02/2017 - ]