Installation [10/2017 - 12/2021]: Procedure

Refer to PROCEDURE - STEP 1

HINT: 

Perform "Inspection After Repair" after replacing an ignition coil assembly.

• w/ Canister Pump Module:

  Refer to INITIALIZATION [02/2017 - ]

• w/o Canister Pump Module:

  Refer to INITIALIZATION [10/2017 - 12/2021]

1. Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   NOTE:

   If an ignition coil assembly has been struck or dropped, replace it.

   HINT: 

   Install the same parts to their original positions.

2. Connect the 4 ignition coil assembly connectors.

See step  4

1. Perform "Inspection After Repair" after replacing a spark plug or ignition coil assembly.
   • w/ Canister Pump Module:

     Refer to INITIALIZATION [02/2017 - ]

   • w/o Canister Pump Module:

     Refer to INITIALIZATION [10/2017 - 12/2021]