Installation [02/2017 - ]: Procedure

1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Adhesive 1344

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   NOTE:

   Do not start the engine within 1 hour of installation.

3. Connect the engine oil pressure switch assembly connector.

Refer to PROCEDURE - Step 6 [02/2017 - 10/2017] , or refer to PROCEDURE - Step 6 [10/2017 - ]

Refer to PROCEDURE - Step 3