LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR LE >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display - Service Information >> Combination Meter >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [05/2018 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 22 [12/2021 - ]

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 23 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 23 [12/2021 - ]

  6. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 24 [12/2021 - ]

  7. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 2 screws.
      GTY744485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clips and guides.
    3. Disconnect the 2 connectors to remove the combination meter assembly.
      GTY769408Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals