Installation [02/2017 - 08/2020]: Procedure

INSTALL COMBINATION METER ASSEMBLY

Connect the 2 connectors to install the combination meter assembly.

Engage the guides and clips.

Install the 2 screws.

INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
Refer to PROCEDURE - Step 15 [02/2017 - 10/2017] , or refer to PROCEDURE - Step 16 [10/2017 - 12/2017] , or refer to PROCEDURE - Step 16 [12/2017 - 05/2018] , or refer to PROCEDURE - Step 18 [05/2018 - 09/2019] , or refer to PROCEDURE - Step 12 [09/2019 - 08/2020]
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 16 [02/2017 - 10/2017] , or refer to PROCEDURE - Step 17 [10/2017 - 12/2017] , or refer to PROCEDURE - Step 17 [12/2017 - 05/2018] , or refer to PROCEDURE - Step 19 [05/2018 - 09/2019] , or refer to PROCEDURE - Step 13 [09/2019 - 08/2020]
INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Refer to PROCEDURE - Step 11 [02/2017 - 10/2017] , or refer to PROCEDURE - Step 11 [10/2017 - 09/2019] , or refer to PROCEDURE - Step 12 [09/2019 - ]
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 17 [02/2017 - 10/2017] , or refer to PROCEDURE - Step 18 [10/2017 - 12/2017] , or refer to PROCEDURE - Step 18 [12/2017 - 05/2018] , or refer to PROCEDURE - Step 20 [05/2018 - 09/2019] , or refer to PROCEDURE - Step 14 [09/2019 - 08/2020]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2017 - 10/2017] , or refer to INITIALIZATION [10/2017 - 05/2018] , or refer to INITIALIZATION [05/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - 08/2020]