LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Avalon TRD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock System (Service Information) >> Rear Door Lock >> Removal [08/2021 -] >> Procedure

Removal [08/2021 -]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 -]

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for HV Model) 

    Refer to PROCEDURE - Step 2

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    for A25A-FKS:

    Refer to PROCEDURE - Step 2

    for A25A-FXS:

    Refer to PROCEDURE - Step 3

    for 2GR-FKS:

    Refer to PROCEDURE - Step 2

  4. REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE REAR DOOR TRIM ASSEMBLY COVER 

    Refer to PROCEDURE - Step 5

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL 

    Refer to PROCEDURE - Step 6

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 7

  8. REMOVE REAR DOOR NO. 1 TRIM BRACKET 

    Refer to PROCEDURE - Step 16

  9. REMOVE REAR DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 17

  10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP 

    Refer to PROCEDURE - Step 18

  11. REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 19

  12. REMOVE REAR DOOR GLASS RUN 

    Refer to PROCEDURE - Step 21

  13. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 22

  14. REMOVE REAR DOOR GLASS SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 27

  15. REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY 
    1. Using a T30 "TORX" socket wrench, remove the 3 screws.
      GTY902639Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Release Plate
      Remove in this Direction
    2. Move the rear door lock with motor assembly downward to disconnect it from the release plate of the rear door outside handle frame sub-assembly, and remove the rear door lock with motor assembly.
    3. When reusing the rear door lock with motor assembly:
      1. Remove the door lock wiring harness seal from the rear door lock with motor assembly.
        GTY863214Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE REAR DOOR LOCK OPEN LEVER REMOTE CONTROL CABLE 
    1. Using a screwdriver, disengage the 2 claws and open the cover as shown in the illustration.
      GTY863215Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the rear door lock open lever remote control cable as shown in the illustration.
      GTY944584Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  17. REMOVE REAR DOOR INSIDE LOCK/UNLOCK KNOB LOCKING CABLE 
    1. Using a screwdriver, disengage the 3 claws and open the cover as shown in the illustration.
      GTY863240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the rear door inside lock/unlock knob locking cable as shown in the illustration.
      GTY860684Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction