Installation [08/2019 - ]: Procedure

INSTALL ACCESSORY METER ASSEMBLY
1. Connect the connector.
2. Install the accessory meter assembly with the 2 screws.
INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS
- For Radio and Display Type:
  Refer to PROCEDURE - Step 8
- For Navigation Receiver Type:
  Refer to PROCEDURE - Step 8
INSTALL HEATER CONTROL ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 3
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 8
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).