Removal [08/2019 - ]: Procedure
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]
- REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Refer to PROCEDURE - Step 4
- REMOVE COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 8 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 8 [08/2022 - ]
- REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 2
- REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Refer to PROCEDURE - Step 4
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 21 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 21 [08/2022 - ]
- REMOVE LOWER INSTRUMENT COVER LH
Refer to PROCEDURE - Step 22 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 22 [08/2022 - ]
- REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE INSTRUMENT PANEL BOX DOOR COVER
Refer to PROCEDURE - Step 24 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 24 [08/2022 - ]
- REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 25 [08/2019 - 08/2022] , or refer to PROCEDURE - Step 25 [08/2022 - ]
- REMOVE DCM (TELEMATICS TRANSCEIVER)
- REMOVE NO. 1 TELEPHONE BRACKET
- REMOVE NO. 2 TELEPHONE BRACKET