Installation [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL SPARK PLUG
Refer to PROCEDURE - Step 1
- INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing a ignition coil assembly.
Refer to INITIALIZATION [11/2018 - 08/2020]
- Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
NOTE:If a ignition coil assembly has been struck or dropped, replace it.
- Connect the 4 ignition coil assembly connectors.
- Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 58