Installation [08/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL SPARK PLUG
Refer to PROCEDURE - Step 1
INSTALL IGNITION COIL ASSEMBLY
HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.

Refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 11/2024] , or refer to INITIALIZATION [11/2024 - ]
1. Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
  Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
  
  NOTE:
  If a ignition coil assembly has been struck or dropped, replace it.
2. Connect the 4 ignition coil assembly connectors.
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 58 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 58 [12/2021 - ]