Installation [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL OIL PRESSURE AND TEMPERATURE SENSOR

Apply adhesive to 2 or 3 threads of the oil pressure and temperature sensor.

Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adhesive 1344
*b	Oil Inlet Port

NOTE:

Do not apply adhesive to the oil inlet port of the oil pressure and temperature sensor.
To prevent contamination by foreign matter, install immediately after applying adhesive.

Using a 24 mm deep socket wrench, install the oil pressure and temperature sensor.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:
Do not start the engine within 1 hour of installation.
Connect the oil pressure and temperature sensor connector.

INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 65 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 65 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 65 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 65 [12/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 66 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 66 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 66 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 66 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 68 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 68 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 68 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 68 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 67 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 67 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 67 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 67 [12/2021 - ]