On-Vehicle Inspection [11/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

FUEL PUMP ASSEMBLY OPERATION

Check fuel pressure.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.

Put the engine in Inspection Mode (Maintenance Mode).

Powertrain > Hybrid Control > Utility

Tester Display
Inspection Mode

Start the engine.

Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.

Powertrain > Engine > Active Test

Active Test Display
Control the Target Fuel Pressure Offset

Data List Display
Fuel Pressure (High)

Select the Data List item: Fuel Pressure (High).
Check that the fuel pressure fluctuates when the target fuel pressure changes.
HINT:

The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.

If the result is not as specified, replace the fuel pump assembly or fuel delivery pipe.

Check operating sound.
1. Remove the No. 1 engine cover sub-assembly.
  Refer to PROCEDURE - Step 26 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 26 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 26 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 26 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 26 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 26 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 26 [10/2023 - ]
2. Start the engine.
3. Using a sound scope, check the operating sound of the fuel pump assembly.
  If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
4. Stop the engine.
5. Install the No. 1 engine cover sub-assembly.
  Refer to PROCEDURE - Step 58 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 58 [02/2019 - 08/2020] , or refer to PROCEDURE - Step 58 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 58 [12/2021 - ]