Removal [08/2020 - 12/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2020 - 12/2021]
REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Refer to REMOVAL [08/2020 - 12/2021]

REMOVE NO. 2 FUEL PRESSURE SENSOR

Disconnect the connector from the No. 2 fuel pressure sensor.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and No. 2 fuel pressure sensor from the fuel delivery pipe sub-assembly.

Remove the No. 2 fuel pressure sensor from the No. 2 fuel pressure sensor holder.