Removal [10/2023 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION

WARNING:

Be sure to read precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [08/2020 - ]

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 3
REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 4

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Refer to REMOVAL [10/2023 - ]

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2023 - ]

REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to REMOVAL [10/2023 - ]

REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

w/ VEHICLE APPROACHING SPEAKER CONTROLLER:

Disconnect the connector.

Disengage the clamp.

Disconnect the 3 hybrid vehicle control ECU assembly connectors as shown in the illustration.

Remove the 2 nuts and hybrid vehicle control ECU assembly.

REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER (w/ VEHICLE APPROACHING SPEAKER CONTROLLER)
Refer to PROCEDURE - Step 7