Installation [04/2018 - ]: Procedure

1. Insert the stop light switch assembly until the threaded sleeve hits the pedal as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Stop Light Switch Mounting Adjuster
   	Insert in this Direction

   NOTE:

   When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

2. Turn the stop light switch assembly 1/4 clockwise as shown in the illustration to install it.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protrusion of the Plunger
   	Turn in this Direction

   Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf 

   or less

   NOTE:

   When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

3. Connect the connector.
4. Check the protrusion of the plunger.
   PROTRUSION OF THE PLUNGER
   
   

   Area	Measurement
   a	0.5 to 2.6 mm (0.0236 to 0.102 in.)

5. If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

   for Gasoline Model:

   Refer to ADJUSTMENT [04/2018 - 08/2020] , or refer to ADJUSTMENT [08/2020 - 08/2021] , or refer to ADJUSTMENT [08/2021 - ]

   for HV Model:

   Refer to ADJUSTMENT [04/2018 - 08/2021] , or refer to ADJUSTMENT [08/2021 - ]

   NOTE:

   Do not depress or support the brake pedal.

Refer to PROCEDURE - Step 47